Old Brittle Filament

Discussion of ANY 3D printing topic you desire!
Posts: 28
Joined: March 24th, 2019, 3:31 am
3D Printer(s): Cocoon Create

Old Brittle Filament

Post by Firepower »

I understand that old brittle filament can be put in an oven to dry it out but wondered if the prints from brittle filament is worse than with new filament.

I can not tell as most of mine have a rough surface. :) Some are quite good. But wondered if the prints are better with new filament?


Return to “General 3D Printing Conversation”