Print a brick

Discussion of ANY 3D printing topic you desire!
Post Reply
Posts: 1
Joined: July 29th, 2018, 7:23 am
3D Printer(s): Flashforge Finder

Print a brick

Post by vintage89 » July 29th, 2018, 7:30 am

Hey all,
I recently found the page, and wanted to try and print som lego sets to build.

I'm experiencing some troubles with the bricks. It seems like the outer wall is to thick, so I can't place two bricks side by side.
Have anybody tried this page sucessfully? What slicer did you use? Settings?

I have a Flashforge Finder 3D printer.

Posts: 116
Joined: October 8th, 2017, 10:21 am
Location: Spain
3D Printer(s): FT-5, JGAurora A5S

Re: Print a brick

Post by Lez0 » July 30th, 2018, 5:01 am

I don't know which brick you downloaded but I downloaded a 2x4 lego brick and measured it.
Real Lego brick 15.78x31.78 downloaded stl file 16x32.
So the 3D model is not to scale. I am guessing Lego have a small gap between the bricks so you can assemble them.
Also I always make 3D models like this about 0.2mm smaller to get a fit as the printer isn't perfect so you get a slight increase in size due to the finish.
I hope this helps.


User avatar
Posts: 3393
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): UM2+,CR-10S (x2),Tevo Tornado,FT-i3/FT-5/FT-6...

Re: Print a brick

Post by LePaul » July 30th, 2018, 11:55 am

I have a friend who prints giant sized legos. (He's the gent that drives BB-8 in the movies)

User avatar
Posts: 438
Joined: February 24th, 2016, 4:48 pm
Location: Örsundsbro, Sweden
3D Printer(s): UMO+

Re: Print a brick

Post by nilrog » July 30th, 2018, 5:35 pm

Afaik Mantisrobot uses brick from and not
But he also says that he tweaked them, but probably mostly because he prints them LARGE :P

Judging form the check Lez0 did you may need to slightly adjust the scale of the brick from printabrick, and also depending on the accuracy of your printer.

Post Reply

Return to “General 3D Printing Conversation”