I had too little time to finish the thumbnails, but I PM’d you beta access
Discussion of ANY 3D printing topic you desire!
- Posts: 122
- Joined: April 21st, 2016, 5:29 pm
- Location: Salford, United Kingdom
- 3D Printer(s): Ultimaker 2
Just tried this out on a 176mb STL file, it opened in just under a second. For files around the 10mb mark, it looks like the app takes longer to start than it does to display the file, so that's as close to instant as possible. Scrolling through files below the 20bm mark is almost instant. Brilliant! Many thanks.