50W Ceramic Cartridge 12/24V Heater For J-Head 3D Printer

Discussion of RepRap style printers!
Post Reply
User avatar
Roberts_Clif
Reactions:
Posts: 399
Joined: March 25th, 2017, 8:17 am
Location: Washington
3D Printer(s): Hictop 3DP11/12

50W Ceramic Cartridge 12/24V Heater For J-Head 3D Printer

Post by Roberts_Clif » July 14th, 2018, 7:32 am

Hello

I ran across A 50W Ceramic Cartridge 12/24V Heater For J-Head 3D Printer on E-bay.
So I decided to ask the question, would there be any benefits in using and would the controllers circuit supply the current to this hot-end heater.
Or would it be necessary to increase the power rating of the hot-end mosfet in order to allow for the changed power rating.
It could be that with the additional 10 watts of power we could get the the heat requirements for some specialty filaments.

Let me know what you think.
Electronics Technician / Computer Programmer

Sometimes the correct answer if not essential to a solution.
If the information provided indirectly leads you to a solution.

Post Reply

Return to “RepRap Printers”

Who is online

Users browsing this forum: No registered users and 4 guests