Page 1 of 1

Newbie help, Prusa i3?

Posted: October 4th, 2020, 6:05 pm
by ShadowSuave
Okay, so I got a 3D Printer from my brother recently that he originally bought from someone. he's had it for a year or 2 now, so I wanted to start from square one with updating firmware/configuration, so on.. the problem I'm running into is we don't know much about it other than it says it's a Prusa i3, and has a Tronxy Melzi 2.0 v5 board. I can't figure out which direction to go as far as firmware, configuration.h, etc. I'll leave pics of the printer and board down below in hopes to maybe identify the hardware I have and/or software I need. I have arduino installed on my pc and tried using Marlin but get nothing but errors when trying to compile a sketch based on a few videos I've watched. it seems like I'm getting nowhere with it 😕 so any help would be GREATLY appreciated! Thanks in advanced for any help 🙂

Prusa i3
Image

Melzi2.0 V5 Tronxy
Image

Re: Newbie help, Prusa i3?

Posted: October 5th, 2020, 7:16 am
by Roberts_Clif
Located a couple web sites that could be of help

https://forum.repetier.com/discussion/7 ... elzi-2-0v5

https://www.thingiverse.com/groups/tron ... opic:16233

This is the firmware for marlin for the tronxy P802E https://github.com/erikkallen/Marlin_tronxy

Re: Newbie help, Prusa i3?

Posted: October 23rd, 2020, 11:08 pm
by jrjong11
Roberts_Clif wrote:
October 5th, 2020, 7:16 am
Located a couple web sites that could be of help

https://forum.repetier.com/discussion/7 ... elzi-2-0v5

https://www.thingiverse.com/groups/tron ... opic:16233

This is the firmware for marlin for the tronxy P802E https://github.com/erikkallen/Marlin_tronxy
Thanks for the help links https aka ms remoteconnect Roberts. Ben looking for these from early morning.
Thanks again!