3D Printing Forum

Two additions!

Usermap allows you to see where users are from, assuming they have entered in their position on the map (note: right click to enter your position once you have set yours up). This is still in development! But i wanted to install it and try it out. If it blows up...we were warned.

Be sure to give your exact location. Drones are expensive to deploy to the wrong location. (Just kidding!!)

mChat is the chat section of the forum. It has a ton of settings so I kept it pretty basic!

As always, thanks for the ideas and your feedback.

GREAT !!!
already saved my position

You can tell the author is from Germany, which is the start location of the map

Clicking the locators shows mileage...neat.

Adjusted start position of map to New York City and a large zoom out.
Changed unit of measure to Miles

Added mine but it's feeling very lonely!

For me the map starts over Boston.

Dim3nsioneer wrote:For me the map starts over Boston.

Guess who's from Maine

LePaul wrote:Adjusted start position of map to New York City and a large zoom out.
Changed unit of measure to Miles

Can you please set it back to metric?

reibuehl wrote:

LePaul wrote:Adjusted start position of map to New York City and a large zoom out.
Changed unit of measure to Miles

Can you please set it back to metric?

Oh yes, please. It would be a pity if we would have to start a third forum...

Amedee wrote:

Dim3nsioneer wrote:For me the map starts over Boston.

Guess who's from Maine

Uhhmm... Boston is in Massachusetts...

Which is not very far from Maine

... But too far from the green side of the world

I really like this as we see that we all live at one world and collaborate to make it better...

Ha ha. Wow I got out voted quick.

Ok. Metric will go back soon

Where's a good starting point for the map?

Can't you just scale it completely out to start with a world map?

I can adjust the zoom level. I'll have to experiment it this evening and point it into the Atlantic