First calibration print from my FT-5
Posted: August 4th, 2017, 10:23 pm
Using Simplify 3D and the default profile in it for the FolgerTech FT-5
Here's the result...retraction speed is 30mm/sec and distance 1 mm (E3D Titan Aero)
I'm sure there's a lot of other tweaks I should make...share the suggestions!
Here's the result...retraction speed is 30mm/sec and distance 1 mm (E3D Titan Aero)
I'm sure there's a lot of other tweaks I should make...share the suggestions!