Death Trooper Helm
Posted: January 16th, 2017, 6:14 am
Hi,
I decided to post this print as this probably is the largest and longest series of prints I probably did with my UMO.
I have already glued together some pieces and I will need to continue the gluing process as well as the sanding one.
Will try to keep this post updated aswell with the post processing of this print
In the meantime, here's how it looks so far
This was printed in white PLA at 0.3 with 40% cubic infill and 1.2 walls.
Next steps:
1- Sanding of pieces
2- Glueing of pieces
3- Sanding of whole
4- Coating with XTC-3D
5- Sanding of whole
6- 3 coatings of black primer
7- Painting (to be reviewed)
8- Green Leds circuitry?
I decided to post this print as this probably is the largest and longest series of prints I probably did with my UMO.
I have already glued together some pieces and I will need to continue the gluing process as well as the sanding one.
Will try to keep this post updated aswell with the post processing of this print
In the meantime, here's how it looks so far
This was printed in white PLA at 0.3 with 40% cubic infill and 1.2 walls.
Next steps:
1- Sanding of pieces
2- Glueing of pieces
3- Sanding of whole
4- Coating with XTC-3D
5- Sanding of whole
6- 3 coatings of black primer
7- Painting (to be reviewed)
8- Green Leds circuitry?