3DP12 pushed to its limits

Show us your latest print!
Post Reply
User avatar
Roberts_Clif
Reactions:
Posts: 785
Joined: March 25th, 2017, 8:17 am
Location: Washington
3D Printer(s): Hictop 3DP11/12

3DP12 pushed to its limits

Post by Roberts_Clif » July 29th, 2019, 11:05 am

Today I pushed my Hictop 3DP12 - 3D Printer to the Ultimate test level.
Printing at layer height of 0.31 with a print speed of 12.4mm^3 per second.

Inside has stringing and under extrusion lines. Most likely because of Z-Hop, incorrect Hot-end temp and flow %.
IMG_2321.JPG
The back wall has Artifacting from infill. Will fix by increasing the wall line count to decrease infill overlap.
IMG_2322.JPG
The front wall has a distinctive start location.
IMG_2323.JPG
Over all not a bad print, for the speed increase.

Any suggestion would be welcome.
Electronics Technician / Computer Programmer

Post Reply

Return to “Show off your latest print”