More issues with cura and bad prints!
Posted: December 4th, 2017, 11:34 am
Im just having a terrible time getting a good print. I have covered the basics and keep running into one issue after another.
Latest issue, cura adding support structure where none is wanted. I have this drawing, has large open areas. I want to print with no support. So, in cura the layer view shows no support, just as I want. However, when it prints, it makes the support framework inside my open areas. Reason I do not want support is because I am printing in armadillo tpu 75d, and this stuff is extremely tough. Its nearly impossible to cut these supports out once its finished. The filament sticks fine on blue tape so no support is needed. Inside the open areas, there is no over hang, just vertical wall.
What am I doing wrong? I am having many troubles with cura not interpreting the stl files correctly.
Latest issue, cura adding support structure where none is wanted. I have this drawing, has large open areas. I want to print with no support. So, in cura the layer view shows no support, just as I want. However, when it prints, it makes the support framework inside my open areas. Reason I do not want support is because I am printing in armadillo tpu 75d, and this stuff is extremely tough. Its nearly impossible to cut these supports out once its finished. The filament sticks fine on blue tape so no support is needed. Inside the open areas, there is no over hang, just vertical wall.
What am I doing wrong? I am having many troubles with cura not interpreting the stl files correctly.