Page 1 of 1
Edges curling up
Posted: August 25th, 2017, 11:23 am
by LePaul
Trouble with overhang I think
Re: Edges curling up
Posted: August 25th, 2017, 11:45 am
by LePaul
Well....I suspect I am printing too fast, so the part isn't cooling enough.
So, lowering from 60 to 50 mm/s
And lowering the PLA temp from 200 to 195
Boy, temps for PLA are quite different from 2.85 to 1.75 it seems?
Re: Edges curling up
Posted: August 26th, 2017, 10:36 am
by GrueMaster
Heh, yes they are.
You might want to do a temp calibration block, changing the temp every 10mm. There are several test objects on thingiverse for this. I found even switching between the different spools that I have there can be a 10 degree variance.
Re: Edges curling up
Posted: August 26th, 2017, 5:20 pm
by LePaul
Small parts really make this an issue. Some medium sized prints were no issue. Still tuning!