[SOLVED] Nylon 910 2.85

Have a print that has problems? Need some feedback? Post it here.
Post Reply
User avatar
ivan.akapulko
Reactions:
Posts: 389
Joined: February 11th, 2016, 11:27 am
Location: Ust-Kamenogorsk, Kazakhstan
3D Printer(s): Ultimaker 2
Contact:

[SOLVED] Nylon 910 2.85

Post by ivan.akapulko » April 5th, 2017, 3:29 am

Hi folks!

Faced with the absence within 3 thousand miles 910 nylon with a diameter of 2.85 mm. Actually, the question to european friends: where you bought this (or some kind of), where there are shipping outside the EU? Manufacturer (Taulman) requests for delivery of one spool an incredible (sic!) $48.

P.S. Paul, if post is not for these section (not completely sure of this), move it to right place, pal.
Last edited by ivan.akapulko on April 7th, 2017, 1:53 am, edited 1 time in total.

User avatar
LePaul
Reactions:
Posts: 3122
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): Ultimaker 2+, FT-5, CR-10, CR-10S, Tevo Tornado
Contact:

Re: Nylon 910 2.85

Post by LePaul » April 5th, 2017, 8:49 am

You're good by me!

User avatar
jonnybischof
Reactions:
Posts: 310
Joined: February 15th, 2016, 2:48 am
Location: Zurich, Switzerland
3D Printer(s): UMO

Re: Nylon 910 2.85

Post by jonnybischof » April 6th, 2017, 7:29 am

http://e3d-online.com/Taulman-Alloy-910 ... .85mm-450g

Estimated shipping to Kazakhstan by Royal Air Mail 5.78£. 10.38£ signed.
A UK store like E3D could be better than an EU one. Having similar problems here in Switzerland :P
Best regards,
Jonny

User avatar
ivan.akapulko
Reactions:
Posts: 389
Joined: February 11th, 2016, 11:27 am
Location: Ust-Kamenogorsk, Kazakhstan
3D Printer(s): Ultimaker 2
Contact:

Re: Nylon 910 2.85

Post by ivan.akapulko » April 7th, 2017, 1:53 am

jonnybischof wrote:http://e3d-online.com/Taulman-Alloy-910 ... .85mm-450g

Estimated shipping to Kazakhstan by Royal Air Mail 5.78£. 10.38£ signed.
A UK store like E3D could be better than an EU one. Having similar problems here in Switzerland :P
Thanks, Jonny!

User avatar
jonnybischof
Reactions:
Posts: 310
Joined: February 15th, 2016, 2:48 am
Location: Zurich, Switzerland
3D Printer(s): UMO

Re: [SOLVED] Nylon 910 2.85

Post by jonnybischof » April 7th, 2017, 3:51 am

You're welcome my friend ;)
Best regards,
Jonny

Post Reply

Return to “Help me fix this print!”

Who is online

Users browsing this forum: No registered users and 2 guests