Overhangs with sharp corners
Posted: December 23rd, 2016, 4:22 pm
Hey guys,
I'm having some trouble when I try to print stuff with overhangs that have sharp corners or small edges in general. They tend to curl up a lot, making the overhangs look pretty bad. Longer edges print just fine. For example I tried to print this christmas tree.
If you zoom in you can see the under side looks very blobby.
I've tried no fans, full fans, a bunch in between, but nothing seems to help.
I sliced it with Cura 2.3.1 using the Spiralize Outer Contour setting (vase mode), printed with PLA at 210 °C and a 0.8mm nozzle.
What's the trick?
I'm having some trouble when I try to print stuff with overhangs that have sharp corners or small edges in general. They tend to curl up a lot, making the overhangs look pretty bad. Longer edges print just fine. For example I tried to print this christmas tree.
If you zoom in you can see the under side looks very blobby.
I've tried no fans, full fans, a bunch in between, but nothing seems to help.
I sliced it with Cura 2.3.1 using the Spiralize Outer Contour setting (vase mode), printed with PLA at 210 °C and a 0.8mm nozzle.
What's the trick?