Odd first layers never seen before.
Posted: November 22nd, 2018, 10:20 pm
Hello everyone,
This is the first time I have really had this problem, I recently got a ezabl mini for my cr-10 nice little device I think I got it tuned in perfectly(to a point) for my machine. I just did a larger scaled print around 200 mm x 200 mm and one corner about 15 millimeters in the filament raises up for 20 mm and then back to my perfect flush first layer the point where it is, isn't even the starting point of the print so no gloop should be there.
I am really stumped and confused by this so any help would be appreciated Thanks
~Max
This is the first time I have really had this problem, I recently got a ezabl mini for my cr-10 nice little device I think I got it tuned in perfectly(to a point) for my machine. I just did a larger scaled print around 200 mm x 200 mm and one corner about 15 millimeters in the filament raises up for 20 mm and then back to my perfect flush first layer the point where it is, isn't even the starting point of the print so no gloop should be there.
I am really stumped and confused by this so any help would be appreciated Thanks
~Max