solve the creality 2.1 board issue..pls help

Have a print that has problems? Need some feedback? Post it here.
Post Reply
laxmansuthar
Reactions:
Posts: 1
Joined: November 1st, 2018, 12:24 pm
3D Printer(s): creality 10s

solve the creality 2.1 board issue..pls help

Post by laxmansuthar »

Dear all , i am a beginner here, i am facing a issue in New purchased creality v2.1 board with led panel, the problem is when i give 12v power to the board via my power supply to test the board it flashing blue lights n screen panel light up but no display coming in panel & the buzzer beep loudly...

pls help me.


regards
laxman
User avatar
GrueMaster
Reactions:
Posts: 522
Joined: March 15th, 2017, 8:46 pm
Location: Oregon
3D Printer(s): Hictop 3DP-17, Hictop CR-10S

Re: solve the creality 2.1 board issue..pls help

Post by GrueMaster »

Sounds like the board may not have been flashed with the right firmware. First, double check that your screen is wired properly (cables swapped?). Next, try to reflash it. You can find several tutorials online, like this one. If that still doesn't work, return to sender as defective.
Post Reply

Return to “Help me fix this print!”