Multiple Print Failures

Have a print that has problems? Need some feedback? Post it here.
Post Reply
Mbur1
Reactions:
Posts: 8
Joined: February 28th, 2019, 8:27 am
3D Printer(s): Creality CR-10 S5

Multiple Print Failures

Post by Mbur1 » March 17th, 2019, 2:29 pm

Hello,
So I purchased a new Creality CR-10 S5 and I have tried multiple prints using PLA and PETG. The parts have not come out decent or not at all. I have tried different temperatures and layer settings. I am using Amazon basics material for all of these. Did I just get a bad machine that I need to send back? I am using Cura 3.6 with recommended setting for the slicing I have been trying different infill amounts to see the difference in strengths. The issues are the layers are not sticking together and a crazy amount of stringing when the head moves around the parts. The area I am running the printer in is dry and room temp around 68. Looking for advice here.
Attachments
Walls Using PLA 205 temp bed at 60.JPG
Samples Parts using PETG 215 temp bed at 70-2.JPG
Samples Parts using PETG 215 temp bed at 70-1.JPG

Post Reply

Return to “Help me fix this print!”