STL previewer?

Post Reply
User avatar
LePaul
Reactions:
Posts: 3204
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): Ultimaker 2+, FT-5, CR-10, CR-10S, Tevo Tornado
Contact:

STL previewer?

Post by LePaul » December 5th, 2016, 6:43 pm

I have a ton of files and rather than open each and every one in Cura....is there a good (Windows) program for previewing the STL files, similar to what we can do for photos?

User avatar
ivan.akapulko
Reactions:
Posts: 389
Joined: February 11th, 2016, 11:27 am
Location: Ust-Kamenogorsk, Kazakhstan
3D Printer(s): Ultimaker 2
Contact:

Re: STL previewer?

Post by ivan.akapulko » December 6th, 2016, 1:26 am


User avatar
LePaul
Reactions:
Posts: 3204
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): Ultimaker 2+, FT-5, CR-10, CR-10S, Tevo Tornado
Contact:

Re: STL previewer?

Post by LePaul » December 6th, 2016, 10:18 am

I'll check that out....I found another one that worked okay, all I had to do was go into Windows File Explorer, turn on the View to Large Icons and I could see the items!

User avatar
ivan.akapulko
Reactions:
Posts: 389
Joined: February 11th, 2016, 11:27 am
Location: Ust-Kamenogorsk, Kazakhstan
3D Printer(s): Ultimaker 2
Contact:

Re: STL previewer?

Post by ivan.akapulko » December 6th, 2016, 10:38 am

Can you share link?

User avatar
LePaul
Reactions:
Posts: 3204
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): Ultimaker 2+, FT-5, CR-10, CR-10S, Tevo Tornado
Contact:

Re: STL previewer?

Post by LePaul » December 6th, 2016, 10:43 am

This message board thread shows info on it

http://community.robo3d.com/index.php?t ... orer.7596/

The download link they list on the 3rd page is this

http://www.pragmaticdesigns.com/K-Studi ... .2.4.0.zip

I registered for a key to use the program...I didn't think to check if one was required or not for the previews to show!

Post Reply

Return to “Other Slicing programs”