STL previewer?
- LePaul
- Reactions:
- Posts: 3262
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): Ultimaker 2+, FT-5, CR-10, CR-10S, Tevo Tornado
- Contact:
STL previewer?
I have a ton of files and rather than open each and every one in Cura....is there a good (Windows) program for previewing the STL files, similar to what we can do for photos?
- ivan.akapulko
- Reactions:
- Posts: 389
- Joined: February 11th, 2016, 11:27 am
- Location: Ust-Kamenogorsk, Kazakhstan
- 3D Printer(s): Ultimaker 2
- Contact:
Re: STL previewer?
http://www.freestlview.com/download.html
Lightweight and fast.
Lightweight and fast.
- LePaul
- Reactions:
- Posts: 3262
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): Ultimaker 2+, FT-5, CR-10, CR-10S, Tevo Tornado
- Contact:
Re: STL previewer?
I'll check that out....I found another one that worked okay, all I had to do was go into Windows File Explorer, turn on the View to Large Icons and I could see the items!
- ivan.akapulko
- Reactions:
- Posts: 389
- Joined: February 11th, 2016, 11:27 am
- Location: Ust-Kamenogorsk, Kazakhstan
- 3D Printer(s): Ultimaker 2
- Contact:
Re: STL previewer?
Can you share link?
- LePaul
- Reactions:
- Posts: 3262
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): Ultimaker 2+, FT-5, CR-10, CR-10S, Tevo Tornado
- Contact:
Re: STL previewer?
This message board thread shows info on it
http://community.robo3d.com/index.php?t ... orer.7596/
The download link they list on the 3rd page is this
http://www.pragmaticdesigns.com/K-Studi ... .2.4.0.zip
I registered for a key to use the program...I didn't think to check if one was required or not for the previews to show!
http://community.robo3d.com/index.php?t ... orer.7596/
The download link they list on the 3rd page is this
http://www.pragmaticdesigns.com/K-Studi ... .2.4.0.zip
I registered for a key to use the program...I didn't think to check if one was required or not for the previews to show!