Print start movement
Posted: January 24th, 2018, 5:03 pm
hello
someone here can tell me if it is possible to change the way S3D move to the printstart point?.
After the homing/autoleveling the nozzle is 10mm from the bed and it moves first the Z-axis
to first layer high and then move XY-axis to the startpoint.
i would like to move XYZ together to go linear to the startpoint ( or first XY then Z )
I think its not that easy because i think its in the slicer programming but maybe it is possible
to change the gcode to get it working.
thanks for the help
someone here can tell me if it is possible to change the way S3D move to the printstart point?.
After the homing/autoleveling the nozzle is 10mm from the bed and it moves first the Z-axis
to first layer high and then move XY-axis to the startpoint.
i would like to move XYZ together to go linear to the startpoint ( or first XY then Z )
I think its not that easy because i think its in the slicer programming but maybe it is possible
to change the gcode to get it working.
thanks for the help