Default Print Speed

Discussion about Simplify 3D software
Post Reply
User avatar
LePaul
Reactions:
Posts: 3024
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): Ultimaker 2+, FT-5, CR-10, CR-10S, Tevo Tornado
Contact:

Default Print Speed

Post by LePaul » March 24th, 2017, 6:02 pm

On my UM2+ Profile I got from Frederik, I see 35%. Is that too slow? Just right?

User avatar
Neotko
Reactions:
Posts: 1142
Joined: February 7th, 2016, 7:02 pm
Location: Madrid
3D Printer(s): UMO+ x2.5
Contact:

Re: Default Print Speed

Post by Neotko » March 24th, 2017, 7:14 pm

35% ? Screenshot pls

User avatar
LePaul
Reactions:
Posts: 3024
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): Ultimaker 2+, FT-5, CR-10, CR-10S, Tevo Tornado
Contact:

Re: Default Print Speed

Post by LePaul » March 24th, 2017, 10:43 pm

Neotko wrote:35% ? Screenshot pls
Capture9.JPG

User avatar
Neotko
Reactions:
Posts: 1142
Joined: February 7th, 2016, 7:02 pm
Location: Madrid
3D Printer(s): UMO+ x2.5
Contact:

Re: Default Print Speed

Post by Neotko » March 25th, 2017, 2:36 am

Ahh 35mm/s no %

Sure is slow. Adjust speed and temp ofc

User avatar
LePaul
Reactions:
Posts: 3024
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): Ultimaker 2+, FT-5, CR-10, CR-10S, Tevo Tornado
Contact:

Re: Default Print Speed

Post by LePaul » March 25th, 2017, 12:19 pm

What would you suggest?

User avatar
Neotko
Reactions:
Posts: 1142
Joined: February 7th, 2016, 7:02 pm
Location: Madrid
3D Printer(s): UMO+ x2.5
Contact:

Re: Default Print Speed

Post by Neotko » March 25th, 2017, 2:11 pm

How can I know? I don't use 2.85mm, nor a um2+ feeder.

You need to test test test test test, and then test a bit more. That's the path to self enlighment

User avatar
LePaul
Reactions:
Posts: 3024
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): Ultimaker 2+, FT-5, CR-10, CR-10S, Tevo Tornado
Contact:

Re: Default Print Speed

Post by LePaul » March 25th, 2017, 3:30 pm

okay

Post Reply

Return to “Simplify 3D”

Who is online

Users browsing this forum: No registered users and 1 guest