Combing

Discussion about Simplify 3D software
Post Reply
User avatar
LePaul
Reactions:
Posts: 3142
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): Ultimaker 2+, FT-5, CR-10, CR-10S, Tevo Tornado
Contact:

Combing

Post by LePaul » February 18th, 2017, 9:13 am

Any ideas how to make this a bit cleaner in S3D?
IMG_5839.JPG
IMG_5840.JPG

User avatar
Neotko
Reactions:
Posts: 1142
Joined: February 7th, 2016, 7:02 pm
Location: Madrid
3D Printer(s): UMO+ x2.5
Contact:

Re: Combing

Post by Neotko » February 18th, 2017, 9:32 am

Horizontal expansion -0.10 that will make the hole text look better, you need to make the texts assuming that pla expands 0.10 otherwise it won't look ok. Also, that's the hardest thing to make look good.

Also, deactivate 'Only retract while crossing open spaces'. But for that you need a feeder that doesn't chew material.

User avatar
LePaul
Reactions:
Posts: 3142
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): Ultimaker 2+, FT-5, CR-10, CR-10S, Tevo Tornado
Contact:

Re: Combing

Post by LePaul » February 18th, 2017, 11:21 am

Thanks. Which tab Ian that under?

User avatar
LePaul
Reactions:
Posts: 3142
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): Ultimaker 2+, FT-5, CR-10, CR-10S, Tevo Tornado
Contact:

Re: Combing

Post by LePaul » February 18th, 2017, 5:30 pm

Home from work....in front of S3D...found the settings! Let's try again

Post Reply

Return to “Simplify 3D”

Who is online

Users browsing this forum: No registered users and 1 guest