Page 1 of 1
Mastering Desktop 3D Printing with Simplify3D - O'Reilly Media
Posted: September 15th, 2016, 8:46 am
by Amedee
From @RichRap3D
Note that it is also available on
Safari (In case you have a subscription there...)
Re: Mastering Desktop 3D Printing with Simplify3D - O'Reilly Media
Posted: September 15th, 2016, 9:50 am
by LePaul
I remember having a lot of the O'Reilly books back when I was working at an Internet Service Provider. Very good documentation
I have a subscription to Lynda.com and the offerings for 3D printing and slicers is pretty bare.
As much as I would like to learn Simplify3d in a formal setting, I'm not crazy about subscribing to another site ($39 a month on Safari)