Mastering Desktop 3D Printing with Simplify3D - O'Reilly Media

Discussion about Simplify 3D software
User avatar
Amedee
Posts: 599
Joined: February 15th, 2016, 11:10 am
Location: Brussels, Belgium
3D Printer(s): UMO / UMO+
Contact:

Mastering Desktop 3D Printing with Simplify3D - O'Reilly Media

Postby Amedee » September 15th, 2016, 8:46 am

From @RichRap3D



Note that it is also available on Safari (In case you have a subscription there...)
Phil.

User avatar
LePaul
Posts: 2093
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): Ultimaker Original HBK, Ultimaker 2+
Contact:

Re: Mastering Desktop 3D Printing with Simplify3D - O'Reilly Media

Postby LePaul » September 15th, 2016, 9:50 am

I remember having a lot of the O'Reilly books back when I was working at an Internet Service Provider. Very good documentation

I have a subscription to Lynda.com and the offerings for 3D printing and slicers is pretty bare.

As much as I would like to learn Simplify3d in a formal setting, I'm not crazy about subscribing to another site ($39 a month on Safari)


Return to “Simplify 3D”

Who is online

Users browsing this forum: No registered users and 2 guests