Simplify Ultimaker Original with Heated bed question
Posted: July 30th, 2016, 11:28 pm
i wanted to try to figure out Simplify 3D (again)
Downloaded the latest installer (3.1.0)
Going through the settings for the Ultimaker 1
Still not a default profile for the Ultimaker with heated bed....annoying...
So in the temp settings I set the PLA temp to 216 I see it uses T0
Now not sure what to set for heated bed?
Downloaded the latest installer (3.1.0)
Going through the settings for the Ultimaker 1
Still not a default profile for the Ultimaker with heated bed....annoying...
So in the temp settings I set the PLA temp to 216 I see it uses T0
Now not sure what to set for heated bed?