3.3.1 Cura takes an hour longer!

Discussion of Ultimaker's open-source Cura software
Post Reply
Lez0
Reactions:
Posts: 53
Joined: October 8th, 2017, 10:21 am
Location: Spain
3D Printer(s): FT-5

3.3.1 Cura takes an hour longer!

Post by Lez0 » April 30th, 2018, 5:53 am

I have just upgraded Cura to 3.3.1
I have a bezel 283x184x18.5 in PLA.
I have some custom setting, but nothing too strange.
In Cura 3.2.1 it takes 8 hours 4 minutes.
I Cura 3.3.1 with the same settings it takes 9 hours 10 mins, according to Cura, which is usually pretty close to guessing the time.
Why an hour longer to print?
Has anybody else noticed this.

Lez0

nallath
Reactions:
Posts: 265
Joined: February 16th, 2016, 3:12 am
3D Printer(s): Ultimaker

Re: 3.3.1 Cura takes an hour longer!

Post by nallath » April 30th, 2018, 8:04 am

Because certain settings might have changed. We constantly tweak settings, but it's impossible to have settings that improve things for everyone.

User avatar
LePaul
Reactions:
Posts: 3099
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): Ultimaker 2+, FT-5, CR-10, CR-10S, Tevo Tornado
Contact:

Re: 3.3.1 Cura takes an hour longer!

Post by LePaul » May 2nd, 2018, 11:53 am

Count yourself lucky !

Do a print with S3D...the print time is about 20% off...it takes a lot longer!

Lez0
Reactions:
Posts: 53
Joined: October 8th, 2017, 10:21 am
Location: Spain
3D Printer(s): FT-5

Re: 3.3.1 Cura takes an hour longer!

Post by Lez0 » May 7th, 2018, 10:09 am

I reported the issue and it seems to have been resolved, it didn't take long.
It's just as well I left version 3.2.1 on the PC when I upgraded to 3.3.1,
I can use the older version to get quicker prints.

ps I wasn't complaining I was just letting everyone know

Post Reply

Return to “Cura”

Who is online

Users browsing this forum: No registered users and 5 guests