Looking for help with older Cura version (15.04) and starting gcode.
Posted: March 10th, 2018, 1:28 pm
This is the version of gcode that Astroprint cloud slicer uses, and I am trying to get my Neva delta printer to heat up to 100, then run calibration, then sit at the front and heat up to the temp set in the slicer, and continue on the print. However with the code below, all it does is heats to 100, calibrates, and then continues on printing at 100.
G90 ;absolute positioning
G28
M109 S100
G29
M104 S{material_print_temperature_layer_0}
G0 X0 Y-85
G0 Z0.26
M109 S{material_print_temperature_layer_0}
M82 ;set extruder to absolute mode
G92 E0 ;zero the extruded length
G1 F200 E6 ;extrude 10mm of feed stock
G92 E0 ;zero the extruded length again
G1 F200 E-3.5
G0 Z0.15
G0 X10
G0 Z3
G1 F{travel_speed}
M117 Printing...
This is what the output looks like in the gcode:
;Generated with Cura_SteamEngine 15.04.6
M109 S195.0
G90 ;absolute positioning
G28
M109 S100
G29
M104 S?material_print_temperature_layer_0?
G0 X0 Y-85
G0 Z0.26
M109 S?material_print_temperature_layer_0?
M82 ;set extruder to absolute mode
G92 E0 ;zero the extruded length
G1
What am I doing wrong?
G90 ;absolute positioning
G28
M109 S100
G29
M104 S{material_print_temperature_layer_0}
G0 X0 Y-85
G0 Z0.26
M109 S{material_print_temperature_layer_0}
M82 ;set extruder to absolute mode
G92 E0 ;zero the extruded length
G1 F200 E6 ;extrude 10mm of feed stock
G92 E0 ;zero the extruded length again
G1 F200 E-3.5
G0 Z0.15
G0 X10
G0 Z3
G1 F{travel_speed}
M117 Printing...
This is what the output looks like in the gcode:
;Generated with Cura_SteamEngine 15.04.6
M109 S195.0
G90 ;absolute positioning
G28
M109 S100
G29
M104 S?material_print_temperature_layer_0?
G0 X0 Y-85
G0 Z0.26
M109 S?material_print_temperature_layer_0?
M82 ;set extruder to absolute mode
G92 E0 ;zero the extruded length
G1
What am I doing wrong?