Discussion of Ultimaker's open-source Cura software
- Posts: 265
- Joined: February 16th, 2016, 3:12 am
- 3D Printer(s): Ultimaker
Because we like pirate speak, cura 2.7 is released with a pirate translation, which can be activated on the 19th of september (today)!
- Posts: 319
- Joined: March 15th, 2017, 8:46 pm
- Location: Oregon
- 3D Printer(s): Hictop 3DP-17, Hictop CR-10S
- Posts: 221
- Joined: February 19th, 2016, 2:13 pm
- Location: Zurich Area, Switzerland
- 3D Printer(s): Ultimaker Original, 2, 2+, 2 Ext+, 3, S5, Form 2
Wait until someone asks for a Parley about Cura!
- Posts: 310
- Joined: February 15th, 2016, 2:48 am
- Location: Zurich, Switzerland
- 3D Printer(s): UMO
Sink with yer ship?
Who is online
Users browsing this forum: No registered users and 1 guest