Hopefully some good feedback for @nallath
1) If you have multiple Octoprints, sometimes Cura will say it can not connect to the Octoprint for the print job (yet you can see the camera)
2) I still use the SD Card from time to time and when you go into Manage Printers and change from RepRap to Ulticode, I suspect the gcode start ups mix together. My printer does the normal home, bed raise, nozzle moves forward, purges....then homes, bed lowers, bed raises, nozzle comes forward and purges again...then prints.
3) I seem to have to re-enter the API for a particular Octoprint from time to time. I'm trying to find the trend to help
Discussion of Ultimaker's open-source Cura software
2 posts • Page 1 of 1