Cura 2.4 is out!

Discussion of Ultimaker's open-source Cura software
Post Reply
User avatar
LePaul
Reactions:
Posts: 3966
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): 24 - Yes I have a problem!
Contact:

Cura 2.4 is out!

Post by LePaul »

User avatar
LePaul
Reactions:
Posts: 3966
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): 24 - Yes I have a problem!
Contact:

Re: Cura 2.4 is out!

Post by LePaul »

p.s. Where do I find if I am running the latest firmware for my Ultimaker 2+ ? And what's available on the UM site?
User avatar
Neotko
Reactions:
Posts: 1142
Joined: February 7th, 2016, 7:02 pm
Location: Madrid
3D Printer(s): UMO+ x2.5
Contact:

Re: Cura 2.4 is out!

Post by Neotko »

I highly doubt they will ever update a um2/um2+ firmware.
User avatar
nilrog
Reactions:
Posts: 438
Joined: February 24th, 2016, 4:48 pm
Location: Örsundsbro, Sweden
3D Printer(s): UMO+

Re: Cura 2.4 is out!

Post by nilrog »

And even if they did...I would use TinkerGnome's FW...just as I use Amedee's FW for my UMO+ :)
User avatar
LePaul
Reactions:
Posts: 3966
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): 24 - Yes I have a problem!
Contact:

Re: Cura 2.4 is out!

Post by LePaul »

I do for my UMO (Amedee)
User avatar
Titus
Reactions:
Posts: 252
Joined: February 9th, 2016, 10:20 pm
3D Printer(s): Ultimaker Original+HBK

Re: Cura 2.4 is out!

Post by Titus »

I still run stock(upgraded ofcourse) firmware for my UMO+HBK :P Isn't there an update from time to time?
Perhaps I should look into Amadee-ware? Any main benefits? I'll look for the topic some day.
Post Reply

Return to “Cura”