Cura 2.3.1 E steps settigns

Discussion of Ultimaker's open-source Cura software
User avatar
antiklesys
Posts: 179
Joined: February 13th, 2016, 8:01 am
3D Printer(s): UMO

Cura 2.3.1 E steps settigns

Postby antiklesys » January 11th, 2017, 5:42 am

Hi,

Does anyone know where to find the E-Steps settings in cura 2.3.1?
It seems it's not in the Machine settings (as in the old cura).
Any clues?

User avatar
LePaul
Posts: 2162
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): Ultimaker Original HBK, Ultimaker 2+
Contact:

Re: Cura 2.3.1 E steps settigns

Postby LePaul » January 11th, 2017, 8:54 am

It's a little ironic...new Cura seems to show me too much, causing confusion. Yet I can't find the good old settings (like Start GCODE, etc) in it :)

User avatar
antiklesys
Posts: 179
Joined: February 13th, 2016, 8:01 am
3D Printer(s): UMO

Re: Cura 2.3.1 E steps settigns

Postby antiklesys » January 11th, 2017, 9:41 am

Start gcode and stuff is now in the machine configuration tab

User avatar
Neotko
Posts: 976
Joined: February 7th, 2016, 7:02 pm
Location: Madrid
3D Printer(s): UMO+ x2.5
Contact:

Re: Cura 2.3.1 E steps settigns

Postby Neotko » January 11th, 2017, 10:10 am

I think they removed the esteps on all 2.x version. You could just add the esteps gcode order on your start gcode?

User avatar
LePaul
Posts: 2162
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): Ultimaker Original HBK, Ultimaker 2+
Contact:

Re: Cura 2.3.1 E steps settigns

Postby LePaul » January 11th, 2017, 10:56 am

antiklesys wrote:Start gcode and stuff is now in the machine configuration tab


Really?

Maybe I have an old version on my work PC I'll go see after installing 2.4 Beta

User avatar
antiklesys
Posts: 179
Joined: February 13th, 2016, 8:01 am
3D Printer(s): UMO

Re: Cura 2.3.1 E steps settigns

Postby antiklesys » January 11th, 2017, 11:27 am

Neotko wrote:I think they removed the esteps on all 2.x version. You could just add the esteps gcode order on your start gcode?


Yes, that's what I did


Return to “Cura”

Who is online

Users browsing this forum: No registered users and 4 guests