This was a good read on infill
http://3dprinting.com/tips-tricks/how-t ... 3d-prints/
Infill
Re: Infill
Except the article is wrong 
Hexagon is not the fastest by a long shot. Especially not if you have machines with heavy heads, as for those the acceleration and de-acceleration is "expensive".
Hexagon is not the fastest by a long shot. Especially not if you have machines with heavy heads, as for those the acceleration and de-acceleration is "expensive".-
LePaul
- Reactions:
- Posts: 3970
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: Infill
Well so far "lines" has proven the strongest on the testing I have done. Triangles and tetrahedral blew up without much effort.
I had been using grid in my BB-8 frame pieces that are failing
I had been using grid in my BB-8 frame pieces that are failing