Infill

Discussion of Ultimaker's open-source Cura software
User avatar
LePaul
Posts: 2162
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): Ultimaker Original HBK, Ultimaker 2+
Contact:

Infill

Postby LePaul » January 3rd, 2017, 11:44 am


nallath
Posts: 185
Joined: February 16th, 2016, 3:12 am
3D Printer(s): Ultimaker

Re: Infill

Postby nallath » January 4th, 2017, 3:50 am

Except the article is wrong ;) Hexagon is not the fastest by a long shot. Especially not if you have machines with heavy heads, as for those the acceleration and de-acceleration is "expensive".

User avatar
LePaul
Posts: 2162
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): Ultimaker Original HBK, Ultimaker 2+
Contact:

Re: Infill

Postby LePaul » January 4th, 2017, 9:24 am

Well so far "lines" has proven the strongest on the testing I have done. Triangles and tetrahedral blew up without much effort.

I had been using grid in my BB-8 frame pieces that are failing


Return to “Cura”

Who is online

Users browsing this forum: No registered users and 2 guests