Cura 4.10.0 crashes on invocation

Discussion of Ultimaker's open-source Cura software
Post Reply
pseakins
Reactions:
Posts: 2
Joined: August 29th, 2021, 11:39 pm
3D Printer(s): Prusa i3 clone

Cura 4.10.0 crashes on invocation

Post by pseakins »

I have been using Slic3r along with pronterface but a recent youtube video was singing the praises of Cura so I thought I would give it a try.
After installation on my W7 system the EXE does not open. It just pops up a Python error box with a bunch of issues. They can't be cut and pasted so can't be shown here.
I deleted it and was going to forget about it but decided it may be worth pursuing.
I suspect Cura is also Python based and perhaps it is hitting conflicts with parts of Python still present from the Pronterface installation.

Just wondering if anyone here may have encountered the same problem and has already found a solution or has suggestions for troubleshooting?
Last edited by pseakins on September 2nd, 2021, 5:37 pm, edited 1 time in total.

User avatar
Roberts_Clif
Reactions:
Posts: 1198
Joined: March 25th, 2017, 8:17 am
Location: Washington
3D Printer(s): Hictop 3DP11/12

Re: Curu 4.10.0 crashes on invocation

Post by Roberts_Clif »

Sorry No::

I have been upgrading Cura from Cura 15.04.6 an have never experienced this problem.

Though have discovered that PrausSlicer the best of all slicers for me.

An by the way it is from Slic3r

Lez0
Reactions:
Posts: 236
Joined: October 8th, 2017, 10:21 am
Location: Spain
3D Printer(s): JGAurora A5S, Anycubic Photon

Re: Curu 4.10.0 crashes on invocation

Post by Lez0 »

I found problems with various versions. so I keep using the old version. Try a different version.

User avatar
LePaul
Reactions:
Posts: 3664
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): I can't name all 14

Re: Curu 4.10.0 crashes on invocation

Post by LePaul »

Have you posted to the Ultimaker Cura forum or Facebook group? They are usually pretty speedy

pseakins
Reactions:
Posts: 2
Joined: August 29th, 2021, 11:39 pm
3D Printer(s): Prusa i3 clone

Re: Cura 4.10.0 crashes on invocation

Post by pseakins »

>Have you posted to the Ultimaker Cura forum
I duplicated the above post and included a screencap. There has been no response.
CuraPythonCrash.jpg

Lez0
Reactions:
Posts: 236
Joined: October 8th, 2017, 10:21 am
Location: Spain
3D Printer(s): JGAurora A5S, Anycubic Photon

Re: Cura 4.10.0 crashes on invocation

Post by Lez0 »

I have been using Cura 4.8 as version 4.9 crashes as soon as I try to import a file.
I have just installed 4.11 and I like the new interface and the way it colours the print.

Lez

Post Reply

Return to “Cura”