Model will slice but won't print

Discussion of Ultimaker's open-source Cura software
tfalcon
Reactions:
Posts: 2
Joined: September 17th, 2020, 9:22 pm
3D Printer(s): Anycubic Predator

Model will slice but won't print

Post by tfalcon »

Hello,

I sliced my model in Cura, seemed to slice okay, but when printed it only printed for about four seconds and then said print complete. Not sure if I am missing a setting in cura?
Attachments
Bin.JPG

User avatar
Roberts_Clif
Reactions:
Posts: 1091
Joined: March 25th, 2017, 8:17 am
Location: Washington
3D Printer(s): Hictop 3DP11/12

Re: Model will slice but won't print

Post by Roberts_Clif »

It would be helpful to post your Cura Settings

Or you could examine my Cura Settings posted here

In some cases we need the Model to be able to do testing, to see what special setting may be required.
OR
Maybe the model has flaws an is in need of repair.
Electronics Technician / Computer Programmer

tfalcon
Reactions:
Posts: 2
Joined: September 17th, 2020, 9:22 pm
3D Printer(s): Anycubic Predator

Re: Model will slice but won't print

Post by tfalcon »

Thank you for your response. The problem seems to be the model, I put it into mesh mixer and tried to go through their repair process and it deleted half the model. Do you mind taking a look at the model? Specifically the one with "bottom" in the name.

https://drive.google.com/drive/folders/ ... sp=sharing

Post Reply

Return to “Cura”