Can't print unless on a raft

Discussion of Ultimaker's open-source Cura software
wwwdotsteve
Reactions:
Posts: 1
Joined: June 11th, 2020, 6:38 am
3D Printer(s): Creality CR-10S

Can't print unless on a raft

Post by wwwdotsteve »

I have a Creality CR 10s and using Cura 4.5.0
I have excellent print quality if I print on a raft, otherwise I get this horrible mess. The bed is level, and the raft prints perfectly as does the part on the raft. I cannot print directly on the bed and sure it is a Cura setting that is causing the problem. Any pointers would be appreciated
Attachments
20 x 30 x10high test print.jpg

User avatar
Roberts_Clif
Reactions:
Posts: 1018
Joined: March 25th, 2017, 8:17 am
Location: Washington
3D Printer(s): Hictop 3DP11/12

Re: Can't print unless on a raft

Post by Roberts_Clif »

Looking at you image of a printed model.
I see that you are starting your print too high above the bed, when you start printing at the correct height you will get a better printed model.
Electronics Technician / Computer Programmer

Post Reply

Return to “Cura”