Page 1 of 1
Cura stuck at 0% infill
Posted: January 25th, 2019, 7:26 pm
by Vainstains
So I opened up cura for wanhao, uploaded a model, but the infill % was stuck at 0%. I deleted all files even named something like cura, redownloaded the software
http://www.wanhao3dprinter.com/Down/Sho ... ticleID=56, and it STILL was locked to 0% infill. common issue?
Re: Cura stuck at 0% infill
Posted: January 25th, 2019, 7:39 pm
by Vainstains
the greyed out digits and symbols means i can't change it
Re: Cura stuck at 0% infill
Posted: January 25th, 2019, 10:01 pm
by GrueMaster
Infill Density looks like 100%, not 0%. Try hitting the arrow (next to the box) to reset to default value.
Re: Cura stuck at 0% infill
Posted: January 25th, 2019, 11:42 pm
by Vainstains
it is greyed out, but that also means that it is set to 0. sorry for being unclear. also, thx, but did not work. still no infill.
This might help the cause?
- Screen Shot 2019-01-25 at 11.47.34 PM.png (11.51 KiB) Viewed 13166 times
Re: Cura stuck at 0% infill
Posted: January 29th, 2019, 9:24 am
by LePaul
Just a shot in the dark here...have you tried downloading the 3.6 Cura and experimenting in there?
Re: Cura stuck at 0% infill
Posted: January 30th, 2019, 10:53 am
by Vainstains
yes, but i only have mac, they all crash, exempt for cura for wanhao. thats what i use.
Re: Cura stuck at 0% infill
Posted: January 30th, 2019, 12:20 pm
by LePaul
I can't say the recent builds have impressed me much....the settings are just a mess...I'm using Simplify 3D more and more these days
Re: Cura stuck at 0% infill
Posted: January 30th, 2019, 12:22 pm
by Vainstains
cura for wanhao is the only thing that works for me. it made me a 1x2x3 rubiks cube... ...right before it lost infill. sometimes i write a very simple geode file from scratch. i made a tetrahedron.
Re: Cura stuck at 0% infill
Posted: February 17th, 2019, 7:50 pm
by Vainstains
Fixed it! just go into printer profiles, exit yours, then enter yours again. Simple!