3D Printing Forum

I bought a sample 225G roll of
Marble filament to see how it looked. Not bad. First print on my CR-10S, no complaints.

Printed at 200c, Bed 60c (have to use a glue stick currently), Layer Height .2, 20% infill. Sorry, forgot to put my US quarter next to it for scale, but it is ~5x1x4.4 CM (so miniature D&D scale).

BTW, this was on draft quality. The layer lines show up more in the photo than they do IRL.

That's pretty neat looking

LePaul wrote: ↑September 30th, 2017, 8:43 am That's pretty neat looking

But they don't make 2.85mm.