AMOLEN Marble Color PLA

Discussion of brand name filaments (ColorFabb Brand, NinjaFlex, Taulman, etc.)
Post Reply
GrueMaster
Reactions:
Posts: 307
Joined: March 15th, 2017, 8:46 pm
Location: Oregon
3D Printer(s): Hictop 3DP-17, Hictop CR-10S

AMOLEN Marble Color PLA

Post by GrueMaster » September 29th, 2017, 10:01 am

I bought a sample 225G roll of
Marble filament to see how it looked. Not bad. First print on my CR-10S, no complaints.

Printed at 200c, Bed 60c (have to use a glue stick currently), Layer Height .2, 20% infill. Sorry, forgot to put my US quarter next to it for scale, but it is ~5x1x4.4 CM (so miniature D&D scale).
marble_wall2.jpg

GrueMaster
Reactions:
Posts: 307
Joined: March 15th, 2017, 8:46 pm
Location: Oregon
3D Printer(s): Hictop 3DP-17, Hictop CR-10S

Re: AMOLEN Marble Color PLA

Post by GrueMaster » September 29th, 2017, 11:37 pm

BTW, this was on draft quality. The layer lines show up more in the photo than they do IRL.

User avatar
LePaul
Reactions:
Posts: 3108
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): Ultimaker 2+, FT-5, CR-10, CR-10S, Tevo Tornado
Contact:

Re: AMOLEN Marble Color PLA

Post by LePaul » September 30th, 2017, 8:43 am

That's pretty neat looking

shurik
Reactions:
Posts: 45
Joined: February 9th, 2016, 9:43 am
Location: Israel
3D Printer(s): UM2

Re: AMOLEN Marble Color PLA

Post by shurik » September 30th, 2017, 4:32 pm

LePaul wrote:
September 30th, 2017, 8:43 am
That's pretty neat looking
But they don't make 2.85mm. :-(

Post Reply

Return to “Special brand filaments”

Who is online

Users browsing this forum: No registered users and 3 guests