ColorFabb HT

Discussion of brand name filaments (ColorFabb Brand, NinjaFlex, Taulman, etc.)
User avatar
Amedee
Reactions:
Posts: 599
Joined: February 15th, 2016, 11:10 am
Location: Brussels, Belgium
3D Printer(s): UMO / UMO+
Contact:

Re: ColorFabb HT

Post by Amedee » May 10th, 2016, 1:56 am

I see something coming here... :oops:

:mrgreen:
Phil.

User avatar
Dim3nsioneer
Reactions:
Posts: 212
Joined: February 19th, 2016, 2:13 pm
Location: Zurich Area, Switzerland
3D Printer(s): Ultimaker Original, Ultimaker 2, Ultimaker 3
Contact:

Re: ColorFabb HT

Post by Dim3nsioneer » July 21st, 2016, 2:03 pm

As I'm a lazy guy: Overhang Test

User avatar
LePaul
Reactions:
Posts: 2578
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): Ultimaker 2+, Folger Tech FT-5
Contact:

Re: ColorFabb HT

Post by LePaul » July 21st, 2016, 2:12 pm

Oh good info...can't use that stuff on a UMO though, right? Due to the high temps required?

User avatar
Dim3nsioneer
Reactions:
Posts: 212
Joined: February 19th, 2016, 2:13 pm
Location: Zurich Area, Switzerland
3D Printer(s): Ultimaker Original, Ultimaker 2, Ultimaker 3
Contact:

Re: ColorFabb HT

Post by Dim3nsioneer » July 22nd, 2016, 1:23 am

Well maybe at 250 or 255°C with a TFT UMO coupler, above that the PEEK will probably say goodbye... but nicest results are actually at those temperatures, maybe not the most adherent ones.

Post Reply

Return to “Special brand filaments”

Who is online

Users browsing this forum: No registered users and 1 guest