Polyalchemy Elixire Gold Rush

Discussion of brand name filaments (ColorFabb Brand, NinjaFlex, Taulman, etc.)
Posts: 6
Joined: August 6th, 2017, 7:09 am
3D Printer(s): Ultimaker 2 - BCN Sigma

Polyalchemy Elixire Gold Rush

Post by B_HepSpringer »

Been trying to print with this stuff but having loads of problems tried different settings in S3D but still rubbish
temp 215
layer ht .20
speed 1450 mm/min
its when the layers change you can see very clearly the change over even in vase mode where the layer changes to the next will post a pic tomorrow but at moment its heading for the Bin..

or I forgot im using the matchless nozzles from 3dSolex

I turned the extrusion multiplier down to 88 from 1.0 which helped a bit, but its still terrible.....

User avatar
Posts: 3498
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): UM2+,CR-10S (x2),Tevo Tornado,FT-i3/FT-5/FT-6...

Re: Polyalchemy Elixire Gold Rush

Post by LePaul »

I've printed with it extensively and did a video on it a while back

Post Reply

Return to “Special brand filaments”