I was looking at the Ultimaker Original files on GitHUB with PDF and STEP formats.
I can't get any of those STEP files to open, in AutoCAD or SolidWorks.
Just me?
STEP files?
-
- Reactions:
- Posts: 415
- Joined: February 8th, 2016, 8:37 pm
- Location: Uppsala, Sweden
- 3D Printer(s): UM2 UM2E, UM2Go, UM3, Delta Tower, Form 1+, Form 2
- Contact:
Re: STEP files?
Works fine for me, in an ancient version of Pro/Engineer.
I saved and unzipped the whole UMO-folder on my hard drive before opening the files, in case you did that differently?
I saved and unzipped the whole UMO-folder on my hard drive before opening the files, in case you did that differently?
- LePaul
- Reactions:
- Posts: 3970
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: STEP files?
Saved file locally and tried to open in Solidworks 2015
- Izzy
- Reactions:
- Posts: 604
- Joined: February 12th, 2016, 2:29 am
- Location: England
- 3D Printer(s): Ultimaker 2
Re: STEP files?
I have the same problem, I have SolidWorks 2012. I have the same problems and unfortunately SW is not backwards comparable, but I have managed to open a few of the files, depends on complexity, I wonder if I can get hold of an old pro engineer copy.
- LePaul
- Reactions:
- Posts: 3970
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: STEP files?
Ok, if i download the entire ZIP file from GitHub, I can open the STEP file. If I let it go through and error check it...then it will crash. So...don't do the second part
- Amedee
- Reactions:
- Posts: 599
- Joined: February 15th, 2016, 11:10 am
- Location: Brussels, Belgium
- 3D Printer(s): UMO / UMO+
- Contact:
Re: STEP files?
Autodesk Fusion 360 imports STEP files