Search found 53 matches
- October 10th, 2016, 1:38 pm
- Forum: Software and Firmware Discussion
- Topic: HIC i3 - current firmware development information
- Replies: 152
- Views: 243386
Re: HIC i3 - current firmware development information
Hello gentlemen I do plenty of my own research, but can someone help me overcome a road block? Could someone point me on the right direction please? So a few weeks back i got the RC6 from here, edited the whole config.h to meet my printer and flashed it. I gotta admit, it all worked great. But last ...
- September 24th, 2016, 10:48 pm
- Forum: Software and Firmware Discussion
- Topic: Mendel inductive sensor z-probe
- Replies: 7
- Views: 13111
Re: Mendel inductive sensor z-probe
marknemo on my hictop u have to replace the switch with the sensor. So it uses the same plug on the motherboard. The firmware on the motherboard does need to be updated. HICTOP gave me one, that works fine, but i can tell accelerations are super high I took Chip's and edited it to make it work on mi...
- September 23rd, 2016, 2:45 pm
- Forum: General Questions
- Topic: Reducing Layer Blobs
- Replies: 8
- Views: 14105
Re: Reducing Layer Blobs
I have been playing with 40 & 45mm speeds... so far so good, blobs are a bit better..... helps that i got Craftware to work again on SD cards... had a problem there for a min where it will stutter on first layer and make blobs,.. seems gone for now. I really liking craftware as their supports te...
- September 19th, 2016, 8:11 pm
- Forum: General Questions
- Topic: Reducing Layer Blobs
- Replies: 8
- Views: 14105
Re: Reducing Layer Blobs
Thanks for the feedback. ill give it a shot and see
- September 18th, 2016, 8:39 pm
- Forum: General Questions
- Topic: Reducing Layer Blobs
- Replies: 8
- Views: 14105
Re: Reducing Layer Blobs
Thank you kindly, I have learned a lot lately for sure. You fine folks sure have a lot of knowledge, and i just want to learn the "dont's" from the best
I just trying to keep my prints from showing this ugly vertical scar along the layers
I just trying to keep my prints from showing this ugly vertical scar along the layers
- September 18th, 2016, 11:15 am
- Forum: General Questions
- Topic: Reducing Layer Blobs
- Replies: 8
- Views: 14105
Reducing Layer Blobs
Good morning folks Been reading a lot and thanks for all the good info. Thanks specially for the marlin firmware settings which made my printer work much better But if i may ask your experience with layer blobs Since the beginning i have had big blobs (the layer start/end) on layer changes... It was...
- September 15th, 2016, 7:24 am
- Forum: Wireless Printing and Controllers
- Topic: OctoPrint
- Replies: 38
- Views: 49880
Re: OctoPrint
It would be so cool if this could install on Android. It already has camera, wifi and plenty storage. I could dedicate one of my old phones to do this task,... Sigh... Time to Google's more about it
- September 14th, 2016, 10:55 am
- Forum: Software and Firmware Discussion
- Topic: Mendel inductive sensor z-probe
- Replies: 7
- Views: 13111
Re: Mendel inductive sensor z-probe
Hello folks. Newbie here. Thank you for having a nice place to learn about these printers. I have the the 3DP_08 version I was trying to use the SN04 hic sells but couldn't get it to trigger with stock bracket without having tip touch bed. So I printed the thingiverse adjustable adapter and while I ...