3D Printing Forum

Well a few things, Creality is giving you specs for their bed. I suspect that stock bed is a 24v bed? You said you went with an AC 500W bed. What thermosistor is that using? There are different types out there, so it may be different that what the Ender 5 Pro's FW is set to You say resin, then ASA, ...

I'm not as savvy with resin as others, but I know there is a issue where suction can pull the part off or deform it

I'm impressed - you've really junked the stock crap from Anycubic and put some quality hardware in there. The Slice Engineering Mosquito Magnum is a great hotend. I don't know anything about Klipper - I just haven't gotten there yet, so I can't offer anything super constructive. Have you checked Red...

I've had to do this a lot with the three CR-10S machines I upgraded to SKR Mini E3 v3 and the TFT35 screens

I upload via vsCode, then after uploading the new firmware, I do an M502 and M500

It sounds like you are using some pre made firmware?

Yeah that's something I encountered on my CR-10 stock hot ends and upgraded to all metal, direct drive setups. The tube would start to get cooked and cause extrusion (under extrusion) issues.

There are a lot of nice upgrades out there. I love the Bondtech DDX upgrades

Dry the material
Then do some calibrations!
https://teachingtechyt.github.io/calibration.html

Do you have a photo of your test print?

Your print got drunk =)

Those look really good

M500 is the command to save to EEPROM

Ha how interesting I was handed a CR-10 Mini for free a year ago and I finally decided to look it over It came without a hot end and I basically gutted it, installed new electronics, touch screen and a second z axis I've spent a lot of time re-learning Marlin with vscode and the plugins. So far, it'...

Summertime! What's everyone up to

Maybe a screen shot?

I've never used one of those, looking at their website i see it uses Klipper and such

I don't have any ideas to offer asides maybe any specific FLSUN groups on Reddit or Facebook?

Did you run a PID Autotune? If this hasn't been set, your firmware can have a hard time getting to and maintaining temperature.

https://teachingtechyt.github.io/calibration.html#pid