3D Printing Forum

I tried it, but I failed to see the benefit of it. But I don't mind if it is there...except for the fact that every forum that has it throws up this annoying "hint".

I found it listed at Hobbex for 129:-
http://m.hobbex.se/sv/artiklar/ca-lim-z ... safe-.html

http://m.hobbex.se/sv/artiklar/accelera ... fe-ca.html

Amedee wrote:I like the 'Purple' one from Zap (Both CA glue and accelerator) because these are less 'aggressive' (foam-safe) and are odorless.

Great, and I can buy it in Sweden. I will put this on my list to try asap

(I found some hints to other types of glue but those were banned in Sweden.)

I just filed a new issue at GitHub regarding the use of a "weird" location for saving user settings on disk in OS X. And the fact that there is no (empty) "plugins" folder in the current folder that indicates where you can put plugins for Cura.

Do you know what can be used to glue/chemical weld all the different filaments like XT, HT & Ngen?

Afaik acetone can be used with ABS and regular superglue with PLA. But I haven't seen anything about the other filaments.

Sounds interesting

Now that is geeky

and i rather pay some more for a flat bed from the start ;) True, but judging from the other forum, even though we pay a premium for UM printers...the parts are not premium. If they were then we would not see all the reports about bad bearings, bent rods etc. They are still good, if not really good...

If you want to tweet the bed level I print 3x 1 layer thick washers, I place 1 close to each bed levelling screw in Cura, run the print, then measure them to find the differences And to verify that your bed is flat you should print one in each corner. "Only" 3 points is still the best sol...

It could be that the glass is not 100% flat in combination with only 3 leveling points.

Some of the upgrades in the kit I'm puzzled that they haven't fixed before. They are small and relatively cheap. Yet improves the printer a lot.

No matter what you do there will be unhappy people. And everyone wants their pieces now (talking about those who only wants part of the whole kit). The current kit is aimed at users who wants a better printer but either doesn't want to, or lack the skills to do all the individual tweaks themselves w...

Interresting...but boy was that video annoying to listen too with all that background chatter...

Thanks for those pointers

I would be interested in a "higher" temp solution for the UMO+ also. But not in the nearest future.