Search found 51 matches
- March 5th, 2017, 9:03 am
- Forum: Software and Firmware Discussion
- Topic: HIC i3 - current firmware development information
- Replies: 152
- Views: 242898
Re: HIC i3 - current firmware development information
I can't say for certain. It is quite likely that the settings are same. You would have to turn the filament sensor section on if you you want to use that, but if that is malfunctioning and keeping you from printing, maybe you just want to keep that section off! The settings for RC7/RC8 are a bit dif...
- February 23rd, 2017, 9:40 pm
- Forum: Software and Firmware Discussion
- Topic: HIC i3 - current firmware development information
- Replies: 152
- Views: 242898
Re: HIC i3 - current firmware development information
I've successfully gotten 1.1.0-RC8BF working with autolevel with bilinear mode on my 3DP-11-AL (which is really a 3DP12). You can find it here . Note: This has auto-leveling enabled and uses 398 steps for Z and the stock SN04-N sensor . So far, the results using the mesh leveling have made significa...
- February 22nd, 2017, 7:32 pm
- Forum: Software and Firmware Discussion
- Topic: HIC i3 - current firmware development information
- Replies: 152
- Views: 242898
Re: HIC i3 - current firmware development information
M119 is gcode to just tell you if your end stops are triggered or not. That way, before you auto home you can check that all your endstops are working correctly and not risk crashing things. Or decrease the risk, anyway.
- February 22nd, 2017, 7:35 am
- Forum: Software and Firmware Discussion
- Topic: HIC i3 - current firmware development information
- Replies: 152
- Views: 242898
Re: HIC i3 - current firmware development information
M119 is your friend when testing out a new firmware!
- February 21st, 2017, 3:07 pm
- Forum: General Questions
- Topic: [SOLVED] - HICTOP I3 CALIBRATION ISSUE
- Replies: 20
- Views: 30189
Re: [SOLVED] - HICTOP I3 CALIBRATION ISSUE
I suspect most of these aluminum beds are bowed. Mine is clearly more concave towards the front than the back, and there are many reports of this. A lot of this is probably because the aluminum is pretty thin and cheap. After autoleveling, this caused everything on the left side of my bed to be squa...
- February 21st, 2017, 2:53 pm
- Forum: Software and Firmware Discussion
- Topic: HIC i3 - current firmware development information
- Replies: 152
- Views: 242898
Re: HIC i3 - current firmware development information
Marlin 1.1.0-RC8 now has bilinear (mesh) based auto bed leveling, which should be much more useful for autoleveling my 3DP12 with concave build plate. As I was working on modifying and compiling the firmware to test out, the power supply on my printer crapped out in the middle of a print. Once I get...