3D Printing Forum

Were you in parallel or series?

You're the best. I'll try that first. If the same results , change the wiring


(At the gym now and it's so nice outside, I'm going to go ride the motorcycle!)

Yes of course. Thanks for that!

I have to check the Ulticontroller for the option Amadee mentioned

I'll check the slow fan option in firmware first

I did get that version from your site


How do I wire this up now?

Fan one pos & neg to Postive lead
Fan two pos & neg to Negative lead ?

This just keeps getting more complicated. Fun

So now to sort out your wiring changes

Well I was noticing the temperature was wandering all over the place first. I removed the shroud and widened the hole IMG_2563.JPG Mounted IMG_2564.JPG I installed Amadee's firmware as well, that was painless. I'm wondering about the fan kick start tho. Since we know my fans are pretty powerful, in ...

So I am using this and wonder, is there a 'stall speed' of sorts? Since my fans have so much force, in Cura I set min to 3% and max to 4%. When the print does the first layer with fans, they puff up then I get max temp error. I tried moving the max up a bit more, same result. I'll post a video in th...

Installed the firmware for my UMO + Heated bed, with the fan kick

Looking forward to trying!

I am noticing the beep on the Ulticontroller sounds different when the fans run (even low). Anyone else get that?

And a little foil tape to protect the wires near the print head

And print head clearance

Some wire work...

I've stuck to 15.04

Well a Facebook friend made a suggestion...remove the shrinktubing, twist the wires up...then (I guess), use electrical tape to hold it all together?

Amedee wrote:Print came OK, now it's the matter of putting everything together and see how it goes with nGen...

Were you able to do that without fan or minimal?

Not a bad print

Now what could've brought that on

I believe...on my fans, they start at 1% on the Ulticontroller. I see the Fan Kickstart...and thinking this could be useful.