3D Printing Forum

I simply melt the 3d printed part with a hot gun. It stays as strong as the original.

Make sure the teflon inside the hotend is pushed all the way down so it has no gaps between it and the brass nozzle. You may have to replace the teflon tube, if you don't have a very straight flat cut on the end. Dear, the teflon tubing will not reach the brass nozzle else it will melt down. it onl...

The stepper toothed wheel is moving but the mechanical counter gear is not moving. This typical issue comes from the fact that your filament is getting blocked quickly at the nozzle end. try the following remedies . 1. Extrude filament manually until you see a good filament melt down at the nozzle. ...

I would recommend using a simple WD40 spray or 3M lubricant spray to clean the nozzle. It is a deadly way of wiping all your filament extrusion issues. Of course care must be taken on the filament plastic . Most of these even reputed brands are not properly rolled over and can cause obstacle while p...