3D Printing Forum

A little background before I finally got a good print. I started my first Print in 2 years thanks to Xayoz posting of the STL file that misplaced.. www.printables.com/model/317026-improved-hictop-i3-x-belt-holder Am using for my 1st 3D Printing project Cura 15.04.6 as the print specs stated that the...

I 3D Printed a few repair parts for my Hictop 3DP11/12 Printers photos shown below
Not bad for years old filament that was left in a plastic box in a non heated / cooled garage for almost 2 years.

I swear by this moisture eliminator I purchased at the local dollar store.

Thank you very much for you suggestions. I had another 3D Printer enthusiast suggest the link below and I decide on that design. https://www.printables.com/model/317026-improved-hictop-i3-x-belt-holder However I did not use the Tie Wrap in fact never noticed it until I came back to get the link for ...

Hello I have a broken HICTOP X-axis Belt Clamp, can not find one anyone have an ideal where to find an STL file

OK. Will try that

Was going to try a Raspberry Pi 4

That is a very good response Le Paul. My Raspberry Pi 2's were replaced with Raspberry Pi 3's at this time. I was using the USB 3 ports for camera's. Then I only took one photo at the end of each layer, showing a layer by layer still frame video when played back. This means at the End of each layer ...

Oh yes I have posted a texture difference when using Octoprint > Octolapse recording feature results below
The above image shows a part printed using Octoprint > Octolapse Part on left that, the print on the right was 3D Printed without octolapse > Octoprint.

Translated One. Increase current: When the motor operates at low speeds, the current decreases, can lead to increased vibration and noise. Two. Reduce load: A heavy load can increased vibration and noise Hi guys, can anyone help me with setting up the stepper motors? All I understand is that they bu...

Have a question that was asked of me an have no way to answer, will post here to see if any of you have an answer So, I just learned a thing.... I have a 3MF file that was sliced on Bambu Slicer. I went to open it on Prusa Slicer and it won't open. So I downloaded Bambu Slicer and it opens beautiful...

I have been away from 3D Printing for far too long. My biggest project is to repair all my 3D Printers, they kind of were not treated as well as expected at the temporary home. And I still have a little work on getting there new home ready for them. though I am doing as well as expected. Still need ...

I have been without my 3D Printers for about 2 years now. Why the home I was living in had no room for them!!! Finally I have made room and look like the home they were in caused a little damage. Need to 3D Print some broken parts, and give them all some extra careful maintenance inspections. Then I...

This is what I get when I set my filament size to 3mm when using 1.75mm filament.

Sample printed image

Isn't that part of the raft that needs to be removed.

Post a larger image so we can see it better

BOTH configuration.h, configuration_adv.h are needed though configuration_adv.h have a lot of options that in simple mode work with default. Most popular 3D Printers have a starting Marlin configuration.h that will supervise until you learn to configure you own custom config. What 3D Printer are you...

I had this problem on my Hictop, as i believe that the display cables were too long. Solved the problem by shielding the cables leading to the Display and created a 3D Printed shielded controller cover. I used Aluminum Foil Tape to line the 3D Printed case and connected a ground wire to the foil at ...