Search found 5 matches
- April 1st, 2017, 8:01 pm
- Forum: General Questions
- Topic: 3DP-17 Proximity Sensor Not Working Properly
- Replies: 2
- Views: 5678
Re: 3DP-17 Proximity Sensor Not Working Properly
Thanks for the reply. I'll take a look at it later to see what results it gives me.
- March 30th, 2017, 3:51 am
- Forum: General Questions
- Topic: 3DP-17 Proximity Sensor Not Working Properly
- Replies: 2
- Views: 5678
3DP-17 Proximity Sensor Not Working Properly
Hello all! I have spent the past few weeks trying to get my new 3DP-17 working and it has been a bit of a nightmare! After finally seeming to get it all dialed in, I encountered an error where the SN04-N sensor's red LED was always on, indicating it is always detecting metal. However, this isn't the...
- March 11th, 2017, 6:34 pm
- Forum: Software and Firmware Discussion
- Topic: Uploading/flashing Marlin to your Hic i3 (or other)
- Replies: 40
- Views: 159475
Re: Uploading/flashing Marlin to your Hic i3 (or other)
Ah ERR: MinTemp... yes I was suffering from that. ...it went when I upgraded to the latest Marlin (bugFix version ):-https://github.com/MarlinFirmware/Marlin/archive/RCBugFix.zip I also had to loosen the grub screw that keeps the thermistor place and push it further into the Extruder! Try that firs...
- March 11th, 2017, 12:00 am
- Forum: Software and Firmware Discussion
- Topic: Uploading/flashing Marlin to your Hic i3 (or other)
- Replies: 40
- Views: 159475
Re: Uploading/flashing Marlin to your Hic i3 (or other)
Thanks for the help! I managed to get it working yesterday using the 1.6.0 IDE. I'll check out that link you provided for me. However, today when I plugged I turned it on I got a mintemp error. No idea what could be causing that since it was working fine yesterday. Time to keep on searching! **EDIT*...
- March 8th, 2017, 10:31 pm
- Forum: Software and Firmware Discussion
- Topic: Uploading/flashing Marlin to your Hic i3 (or other)
- Replies: 40
- Views: 159475
Re: Uploading/flashing Marlin to your Hic i3 (or other)
Thanks for all the help everyone! This has been an invaluable resource since I recently purchased a 3DP-17 and couldn't use it since it was always giving me a "change filament" error. I have two questions so far. First off, I'm running into one small problem using Arduino's 1.0.6 IDE. I am...