Search found 5 matches

by AlmostAnEngineer
April 1st, 2017, 8:01 pm
Forum: General Questions
Topic: 3DP-17 Proximity Sensor Not Working Properly
Replies: 2
Views: 5629

Re: 3DP-17 Proximity Sensor Not Working Properly

Thanks for the reply. I'll take a look at it later to see what results it gives me.
by AlmostAnEngineer
March 30th, 2017, 3:51 am
Forum: General Questions
Topic: 3DP-17 Proximity Sensor Not Working Properly
Replies: 2
Views: 5629

3DP-17 Proximity Sensor Not Working Properly

Hello all! I have spent the past few weeks trying to get my new 3DP-17 working and it has been a bit of a nightmare! After finally seeming to get it all dialed in, I encountered an error where the SN04-N sensor's red LED was always on, indicating it is always detecting metal. However, this isn't the...
by AlmostAnEngineer
March 11th, 2017, 6:34 pm
Forum: Software and Firmware Discussion
Topic: Uploading/flashing Marlin to your Hic i3 (or other)
Replies: 40
Views: 156741

Re: Uploading/flashing Marlin to your Hic i3 (or other)

Ah ERR: MinTemp... yes I was suffering from that. ...it went when I upgraded to the latest Marlin (bugFix version ):-https://github.com/MarlinFirmware/Marlin/archive/RCBugFix.zip I also had to loosen the grub screw that keeps the thermistor place and push it further into the Extruder! Try that firs...
by AlmostAnEngineer
March 11th, 2017, 12:00 am
Forum: Software and Firmware Discussion
Topic: Uploading/flashing Marlin to your Hic i3 (or other)
Replies: 40
Views: 156741

Re: Uploading/flashing Marlin to your Hic i3 (or other)

Thanks for the help! I managed to get it working yesterday using the 1.6.0 IDE. I'll check out that link you provided for me. However, today when I plugged I turned it on I got a mintemp error. No idea what could be causing that since it was working fine yesterday. Time to keep on searching! **EDIT*...
by AlmostAnEngineer
March 8th, 2017, 10:31 pm
Forum: Software and Firmware Discussion
Topic: Uploading/flashing Marlin to your Hic i3 (or other)
Replies: 40
Views: 156741

Re: Uploading/flashing Marlin to your Hic i3 (or other)

Thanks for all the help everyone! This has been an invaluable resource since I recently purchased a 3DP-17 and couldn't use it since it was always giving me a "change filament" error. I have two questions so far. First off, I'm running into one small problem using Arduino's 1.0.6 IDE. I am...

Go to advanced search